How It Works
Shape first, then tint. That's the order a salon works in, and it's the reason a professional brow looks finished and a home brow usually doesn't. Here's the whole method — about 25 minutes, most of which is waiting.
What you need
- A Browe precision brow razor (a fresh one if yours drags)
- Browe peel-off brow tint in your shade — the 1.2 mm angled brush is built into the cap
- Tweezers, if you have a pair, for any strays the razor can't reach
- A mirror with decent light and ten quiet minutes
Step 1 — Shape (about 5 minutes)
Start with clean, dry, product-free skin. Oil and moisturiser make the razor skid.
- Brush your brows straight up so you can see the real shape underneath, not the shape your brow gel has been faking.
- Hold the skin taut with your free hand. This matters more than anything else — loose skin is where nicks happen.
- Glide the razor at a shallow angle in short strokes, working under the arch and along the tail. Never press. The blade does the work.
- Take off the peach fuzz on the surrounding skin while you're there — it's why foundation catches.
- Rinse the blade, pat your skin dry, and look again before you take more off. You can always remove more; you can't put it back.
Step 2 — Tint (about 5 minutes to apply)
- Tidy any strays you missed. Tint over a stray hair makes it more obvious, not less.
- Make sure the skin is completely dry and oil-free.
- Outline the shape you want with the angled brush — thin, deliberate strokes at the edges.
- Fill the outline with a smooth, even layer. This is the step people rush. Thin patches peel badly and leave gaps, so keep the layer consistent all the way to the tail.
Step 3 — Wait, then peel (about 20 minutes)
- Leave it roughly 20 minutes. It's ready when it's fully set and no longer tacky to a light touch.
- Lift one edge — the tail is easiest — and pull the film off in a single piece, slowly, along the direction of the hair.
- Keep the area away from water, cleanser and oils for the next few hours so the colour settles.
How often to repeat
Most people shape every one to two weeks and re-tint every three days or so, depending on skin type and routine. The razors are washable and reusable, so one pack of six lasts a good while.
Getting the best result
- Shade: match your roots, not your dyed lengths. Between two shades, go lighter — tint reads darker on skin than in the tube.
- Depth: the longer the gel sits before you peel, the deeper the colour develops. Start at 20 minutes and adjust from there.
- Longevity: the biggest thing that shortens a tint is scrubbing. Be gentle with cleanser around the brow area and skip exfoliating acids there.
- First time: patch-test the tint 24 hours before, and do your first application on an evening when you're not going anywhere.
When not to do this
Skip both steps over broken, irritated, sunburned or actively breaking-out skin, and don't apply tint to lashes or inside the eye area. These are cosmetic products, not treatments — if you're under a dermatologist's care or you have a known cosmetic allergy, check with them first.